|
|||||||||||||||||||||||||||
Have you always had a little itch to make your own lamp? Perhaps you have thought of something that would be a darling lamp base, such as that petite birdhouse that you have sitting on your coffee table, but that is as far as your idea went, because you were a little overwhelmed? Thanks to this Screw-In Electric Lamp Kit, you can be further inspired to make your decorative vision a reality!
This kit includes a standard brass finish socket and brown cord set, an adapter, a riser, a hex nut, a hanger bolt, and instructions to guide you along the way. That's all you need, and it's that simple! Instructions: Screw the brass adapter into the socket until it is fully seated. Screw the hex nut onto the hanger bolt until approximately 1/8-inch of the bolt is exposed. Just a few turns will do to keep it secure. The wire or socket could get damaged if it is too tight. Slip the riser over the bolt and nut so that it rests on the nut. Screw the hanger bolt and and riser into the adapter, gently, until you can just feel the hex nut begin to tighten. With your fingers, grasp the riser and turn it clockwise until it is tight against the socket. Drill a 3/16-inch pilot hole in your birdhouse or other base where you wish to assemble your socket. Screw the socket into this hole until it is fully seated. If your surface has an incline, or peaked roof, create a flat surface by making a v-shaped "chimney" to fit the roof. These step-by-step instructions are included in this kit, along with diagrams of the parts, to ensure you the best lamp creation! Makes one lamp.
|
|||||||||||||||||||||||||||
|
Change Your Country
Please Correct The Following